Wheel Card Instructions
To
make the wheel card, you start off with a 8 1/2 x 5 1/2 sheet of cardstock
folded in half like a standard card. Use large circle punch to make
circular hole in the middle top of the card front.
For the wheel, use the Coluzzle® cutting system to cut a circle shape (I used the second largest circle) out of cardstock. Punch a tiny hole for the eyelet using the anywhere hole punch and a ruler in the middle of the circle (if you making a bunch then use this one as your template. After cutting more circles, put this circle on top and then use the anywhere hole punch to punch the small center hole without having to measure it each time).
Open the card up and put the large circle made with Coluzzle® in the center of the inside front cover. The small hole should be centered under the 1" hole made with the large circle punch. Also make sure the edge is not bunched up against the fold of the card. Use the small hole as a guide to make small hole in the cardfront using the anywhere hole punch.
Remove Coluzzle® circle and set aside.
Fold the card again, and using the large square punch, punch 1/3 to 1/2 of the square in the right side of the card (cutting into both the front and back of the card.) Make sure it is centered with the eyelet hole.
Stamp front cover as desired.
Now attach the Coluzzle® circle to the inside front cover with an eyelet - making sure to not hammer too much!! You want to be able to turn the wheel!! Make sure the wheel will turn easily. If it is too close to the fold, you can trim a little off.
Go back to the front and sponge some ink through the hole. Turn the circle a quarter turn, and sponge again, repeating until you have four sponged circles as you turn the wheel.
Stamp inside each circle as desired (Good sets for this are Good Times. A little Love, Mini Mates, etc).
Open up and stamp inside as desired. You are done!!!!!!!!!
Go back to Convention Samples.
Check out another project:
